Can I paint each piece separately before installation?

Yes. The three-piece design lets you prep and finish the front bumper, side skirts, and rear bumper individually on sawhorses or a workbench. This is often cleaner than masking around mounted panels. Sand the primer surface with your preferred grit and apply your finish in a controlled environment.

Will these panels bolt to my factory attachment points?

The kit is molded to factory mounting point locations, but verify your specific hardware and fastener positions before drilling or fastening. Check your vehicle's service manual or OEM diagrams to confirm hole alignment and fastener type.

Do I need filler or seam tape where panels meet?

Gap management between the front bumper, side skirts, and rear bumper depends on your fitment and bodyline alignment. Standard approach is to fill seams with panel adhesive or fiberglass-compatible filler after installation, then sand and finish. Test-fit before final fastening to minimize gaps.