Will this bumper work with my OEM fog light cutouts?

The B-2 profile is designed as a direct replacement for the factory bumper. Before installation, compare your vehicle's existing fog hole locations to the cover geometry to confirm alignment. If modifications are needed, mark cutout locations with tape and drill carefully after a test fit.

Can I install this myself with basic tools?

Yes. Standard hand tools and a drill (if needed for mounting holes) are sufficient. Start with a dry fit to verify alignment with your frame and existing attachment points, then remove, sand prep the contact areas, and secure according to your vehicle's mounting structure.

What prep work is required before painting?

Sand the entire surface with appropriate grit to promote paint adhesion, then clean away all dust and debris. The raw FRP surface bonds well with quality automotive primers and top coats—use products designed for plastic substrates for best results.