Will this fit with my existing fog lights and sensor cutouts?

Verify the location of any factory fog light openings and sensor holes on your current bumper before installation. You may need to mark and carefully cut those openings into the FRP panel to match your OEM configuration. A rotary tool or fine saw works well for precise cuts in fiberglass.

Does this bumper extend further back than the factory piece?

The M-Tech profile sits within standard bumper depth. Compare the rear edge of your OEM bumper to the panel before final installation to ensure clearance with any aftermarket diffusers, exhausts, or tow equipment.

What prep work should I do before painting?

Sand the surface with appropriate grit to promote adhesion, then clean thoroughly to remove dust and residue. Once prepped, apply your chosen primer and topcoat according to paint system instructions. The FRP accepts standard automotive finishes without additional sealer required.