Will these skirts interfere with my factory jack points?

Demon rockers extend lower than stock, so verify clearance at your vehicle's jack point locations before final installation. You may need to adjust your lifting method or use a reinforced pad. Check your service manual for OEM jack point placement and compare against the installed rocker profile.

Do I need to drill mounting holes or can I use adhesive?

FRP panels like these are typically bolted through factory or new mounting holes. Adhesive alone is not recommended for side skirts, which endure road flexing and impact. Drill pilot holes carefully and use stainless fasteners to avoid corrosion over time.

What prep is needed before painting?

Sand the surface with appropriate grit to create tooth for your paint system, then wipe clean of dust. Follow your paint manufacturer's instructions for primer and topcoat application. FRP can chip if struck hard, so gentle handling during prep and installation prevents damage.