Will these skirts interfere with my jack points?

The B-2 profile is designed with factory jack-point access in mind. Before final installation, verify clearance at your vehicle's designated lift points and avoid mounting hardware that would obstruct the pinch weld area. You may need to trim or route the panel slightly depending on your lift equipment setup.

What's the best way to prep FRP for paint?

Sand the surface with progressively finer abrasives to smooth any mold lines and promote adhesion. Wipe down thoroughly to remove dust, then apply your chosen primer and topcoat system. FRP responds well to standard automotive epoxy or polyester primers — verify compatibility with your paint supplier before application.

Do these bolt to existing factory holes, or do I need to drill new ones?

These panels are engineered to use factory mounting points. Inspect your vehicle's rocker and door jamb area for existing fastener locations before drilling. Once you've confirmed hole position, test-fit the panel dry to ensure alignment with the body line before final fastening.